Checking The Installed Position Of The Sensor Wheel On The Crankshaft:

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Install the nut -B- up to the end of the threaded spindle.

-- Remove both bolts -2- from the cylinder block.

-- Remove the knurled bolts -H- from the sealing flange -1-.

-- Remove the hex socket bolts -E- from the crankshaft flange and remove the :T10134 from the crankshaft flange.

-- Remove the sealing lip support ring.

-- Attach the :VAS6082 to the crankshaft flange -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Measure the distance -a- between the crankshaft flange -2- and the sensor wheel -1-.

Courtesy of AUDI OF AMERICA, LLC

Specified value: dimension -a- = 0.5 mm

-- Install the sensor wheel again if the measured value is too small. Refer to TRANSMISSION SIDE SEALING FLANGE, REMOVING AND INSTALLING, CRANKSHAFT FLANGE WITH SIX CONNECTION AREAS .

-- When the specified value is reached, perform the rest of the assembly. Refer to TRANSMISSION SIDE SEALING FLANGE, REMOVING AND INSTALLING, CRANKSHAFT FLANGE WITH SIX CONNECTION AREAS .