Overview - Electric Vacuum Pump
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2017 Audi A3, and 2016 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Clean the bolts and nuts before reusing.
Always replace self-locking nuts and bolts.
Always replace damaged nuts and bolts.
- Brake System Vacuum Pump -V192-
- Allocation. Refer to the Parts Information.
- Component location: in the engine compartment above the engine/transmission separating point.
- Do not disassemble
- Check in "Guided Fault Finding" using the Vehicle Diagnostic Tester.
- Removing and Installing. Refer to ELECTRIC VACUUM PUMP, REMOVING AND INSTALLING .
- Vacuum Line
- With brake booster pressure sensor
- Allocation. Refer to the Parts Information.
- Bracket
- Bolt
- 8 Nm
- Quantity: 2
- Rubber Bushing
- Quantity: 3
- Do not push out of the bracket when installing
- Bolt
- 25 Nm
- Bracket
- Secured on the transmission
NOTE:
Clean the bolts and nuts before reusing.
Always replace self-locking nuts and bolts.
Always replace damaged nuts and bolts.