Overview - SUBFRAME Mount, Vehicles With Manual Transmission 02S: Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Subframe Mount, Vehicles With Manual Transmission 02S

Courtesy of AUDI OF AMERICA, LLC

Engine Support
- Removing and installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
Bolt
- Tightening specification and sequence. Refer to INSTALLING THE PENDULUM SUPPORT .
- Always replace
Engine Mount
- With support arm
- Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
Bolt
- 40 Nm +90°
- Always replace
Bolt
- 20 Nm +90°
- Always replace
Bracket
- For the coolant check valve
Bolt
- 8 Nm
Bolt
- 60 Nm +90°
- Always replace
Bolt
- Tightening specification and sequence. Refer to INSTALLING THE PENDULUM SUPPORT .
- Always replace
Pendulum Support
- Removing and installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
Bolt
- Tightening specification and sequence. Refer to INSTALLING THE PENDULUM SUPPORT .
- Always replace
Bolt
- Tightening specification and sequence. Refer to INSTALLING THE PENDULUM SUPPORT v.
- Always replace
Bolt
- 60 Nm +90°
- Always replace
Bolt
- 60 Nm +90°
- Always replace
Transmission Mount
- With support arm
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
Bolt
- 50 Nm + 90°
- Always replace
Transmission Support
Bolt
- Tightening specification. Refer to SUBFRAME MOUNT [For transmission(s) 0D9] .
Bolt
- Tightening specification. Refer to SUBFRAME MOUNT [For transmission(s) 0D9] .
Brace
Bolt
- Tightening specification. Refer to SUBFRAME MOUNT [For transmission(s) 0D9] .