Overview - Selector Mechanism
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Selector Lever Cable
- Nut
- 8 Nm
- For selector mechanism to body
- Quantity: 4
- Bolt
- 4 Nm
- For attaching the selector mechanism to the selector housing
- Quantity: 4
- Selector Mechanism Function Unit
- With a permanent circuit board for the selector mechanism (Selector Lever -E313-)
- With integrated Selector Lever -E313- with Selector Lever Sensor System Control Module -J587-, Selector Lever Park Position Lock Switch -F319- and Shift Lock Solenoid -N110-
- Checking Vehicle Diagnostic Tester, Guided Fault Finding
- Selector Lever -E313- with elector Lever Sensor System Control Module -J587-, Selector Lever Park Position Lock Switch -F319- and Magnet for Shift Lock Solenoid -N110- can be replaced with the shift mechanism function unit only. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING
- Selector lever cable can only be replaced with the selector mechanism. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING .
- Perform selector mechanism emergency release. Refer to EMERGENCY RELEASE FROM P .
- Removing and installing. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING .
- Do not lubricate the selector lever cable
- Selector Housing
- Base Plate
- Always replace after removing
- Clips
- Always replace after removing
- Bolt
- 13 Nm
- Selector lever cable adjusting screw
- Joint Piece
- Selector Lever
- Nut
- 20 Nm
- Lock Washer
- Cable Mounting Bracket
- For selector lever cable
- Bolt
- 15 Nm