Transmission Fluid Pump, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Risk of transmission damage.
- Do not run engine or tow the vehicle with transmission fluid pan removed or without transmission fluid.
NOTE:
Follow the rules for clean working conditions. Refer to CLEAN WORKING CONDITIONS .
General repair instructions. Refer to GENERAL REPAIR INFORMATION .
-- Drain gear oil. Refer to TRANSMISSION FLUID, DRAINING AND FILLING and leave :SMN372500 below.
-- Remove the left front wheel housing liner. Refer to WHEEL HOUSING LINER .
-- Remove the bolts -arrows- and remove the transmission fluid pump cover -A- while letting the gear oil remaining in cover drain into :SMN372500 .
-- Remove the bolts, use the :T10054 for the upper bolt -arrow-.
-- Remove the transmission fluid pump from the alignment pins and the input shaft.