Overview - MECHATRONIC
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Drain and Check Plug
- 45 Nm
- Seal
- Always replace after removing
- Overflow Pipe
- 3 Nm
- Bolt
- Tightening specification and sequence. Refer to appropriate service information
- Always replace after removing
- Quantity: 10
- Oil Pan
- Removing and installing. Refer to OIL PAN, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to
- Always replace after removing
- Quantity: 5
- Gasket
- Always replace after removing
- DSG Transmission Mechatronic -J743-
- With O-rings on connector
- Always replace the O-ring after disassembly.
- Removing and installing. Refer to Direct Transmission Mechatronic -J743-, REMOVING AND INSTALLING
- Bleed Cap
- Placed on bleed pipe
- Bleed Pipe
- Pressed into transmission
- Always replace after removing
- Transmission Oil Pump
- Removing and installing. Refer to TRANSMISSION FLUID PUMP, REMOVING AND INSTALLING .
- Insert with new seal
- Transmission Oil Pump Cover
- With seal
- Always replace after removing
- Removing and installing. Refer to TRANSMISSION FLUID PUMP, REMOVING AND INSTALLING
- Bolt
- Tightening specification and sequence. Refer to
- Always replace after removing
- Quantity: 4
- Bolt
- Tightening specification and sequence. Refer to
- Always replace after removing
- Quantity: 4
- Different versions. For the correct allocation. Refer to the parts information.
- Gasket
- Always replace after removing
-- Tighten the screws -arrows- diagonally in steps to 16 Nm.
NOTE:
Replace the bolts that were tightened with an additional turn.
-- Tighten the bolts in steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 10- | 5 Nm |
| 2. | -1 to 10- | Tighten 90° further |
-- Tighten the screws -arrows- diagonally in steps to 8 Nm.
NOTE:
Replace the bolts.
NOTE:
Replace the bolts that were tightened with an additional turn.
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | Upper countersink bolt | 8 Nm with Wrench - Pump/Injector Long Reach:T10054 |
| 2. | Flat head screws | 8 Nm |
| 3. | Flat head screws | Tighten 90° further |