Bevel Box, Removing

Special tools and workshop equipment required 

• Engine Sling - Engine Bracket:2024A/1 
• Engine Support Device:3300A 
• Socket And Extended Bit:T10107A 

Mandatory Replacement Parts 

• Nut - Coupling Rod
• Bolt - Coupling Rod
• Nuts - Ball Joint
• Bolts - Driveshaft
• Bolts - Bevel Box

PROCEDURE 

-- Remove the rear noise insulation. Refer to NOISE INSULATION .

-- Remove the pendulum support. Refer to ASSEMBLY MOUNTS [For engine(s) CRUA, DEJA] Assembly Mounts or ASSEMBLY MOUNTS [For engine(s) CRUA, DEJA] .

Courtesy of AUDI OF AMERICA, LLC

Vehicles with a TFSI Engine 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrows- and remove the right drive axle heat shield.

Vehicles with TDI Engine 

Courtesy of AUDI OF AMERICA, LLC

-- Remove EGR cooler. Refer EXHAUST PIPES/MUFFLERS .

All Vehicles 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and remove the heat shield -1-.

-- Remove the nut -1- for the coupling rod -3- from the right of the stabilizer bar -2-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The illustration that follows shows the left front wheel suspension.

Courtesy of AUDI OF AMERICA, LLC

-- Mark the position of the nuts -arrows- for the right ball joint, and remove them.

-- Remove the right ball joint from the transverse link.

-- Remove right drive axle from bevel box. Refer to DRIVE AXLE .

-- Tie up the drives axle.

-- Move the right suspension strut to the outside and support it with the :2024A/1  as illustrated.

Courtesy of AUDI OF AMERICA, LLC

-- Mark the position of the flexible disc and the bevel box flange shaft to each other for later use.

Courtesy of AUDI OF AMERICA, LLC

-- Using a lever to counterhold the triangular flange, remove the driveshaft from the bevel box -arrows-.

-- Press engine/transmission assembly forward slightly and remove driveshaft from bevel box.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -arrow- on the Oil Level Thermal Sensor -G266-.

Courtesy of AUDI OF AMERICA, LLC

Vehicles with a TFSI Engine 

Courtesy of AUDI OF AMERICA, LLC

-- Remove bolts -1 and 2- and the bevel box bracket.

Vehicles with TDI Engine 

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

-- Remove the bolt -arrow-, and push the Heater Support Pump -V488- aside.

-- Remove bolts -1 and 2- and the bevel box bracket.

Courtesy of AUDI OF AMERICA, LLC

All Vehicles 

Courtesy of AUDI OF AMERICA, LLC

-- Remove right flange shaft bolt with :T10107  by installing two bolts in the flange and counter holding flange shaft with assembly lever.

-- Remove the bolts -arrows- that connect the bevel box to the S tronic transmission.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the :3300A  on the subframe.

Courtesy of AUDI OF AMERICA, LLC

-- Place the :3300A  spindle on the transmission, as show in the illustration.

-- Only push the engine/transmission assembly with the :3300A  spindles so far forward until the bevel box can be removed.

-- Carefully press bevel box off the S tronic transmission while protecting it against falling through.

-- Remove the bevel box together with the flange shaft.