Vibration Damper Seal, Replacing: Procedure: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
-- Remove the seal -arrow- with the :T40274 .
-- Clean the contact and sealing surface.
-- Push the seal -arrow- on the :T10354 .
- The closed side of the seal points to the :T10354 .
-- Push the seal -arrow- with the :T10354 on the :T10531/2 and place on the lower timing chain cover.
-- Additionally attach the :T10375 and tighten the :T10531/4 .
-- Drive the seal in all the way using the :T10354 .