Overview - Cylinder Head: Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Alignment Pin
- Quantity: 2
- Cylinder Head Gasket
- Always replace after removing
- Installed position: the part number faces the cylinder head
- Change the coolant and engine oil after replacing
- Cylinder Head
- Checking For Distortion. Refer to Figure.
- Change the coolant and engine oil after replacing
- Removing and installing. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
- Bolt
- Heat Shield
- Equipped on some models
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Heat Shield
- There are different versions. Refer to the parts information for the allocation.
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Connection
- For coolant hose
- O-ring
- Always replace after removing
- Coat with coolant
- Bolt
- O-ring
- Always replace after removing
- Coat with coolant
- Connection
- For coolant hose
- Bolt
- 9 Nm
- Mount
- For the engine cover
- Engine Lifting Eye
- Bolt
- 10 Nm + 90°
- Always replace after removing
- Partition Plate
- Ball Pin
- For the engine cover
- Engine Lifting Eye
- Bolt
- 10 Nm + 90°
- Always replace after removing
- Alignment Pin
-- Remove the bolts -arrows-.
-- Loosen and remove the cylinder head bolts in the sequence -1 to 10-.
- Replace the bolts that were tightened with an additional turn after removing them.
NOTE:
The strength category of the bolts is specified on the bolt head.