LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (COOLING SYSTEM (4-Cylinder Direct Injection 1.8L; 2.0L 4V TFSI Engine) -- (A3 SEDAN)) >> 19 Cooling System >> Radiator/Radiator Fan >> Radiator, Removing And Installing >> Installing

Radiator, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2016 Audi S3, 2016 Audi A3, and 2015 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

If there are small impressions on the slats. Refer to appropriate service information. .

Replace the O-rings.

-- Install the front bumper cover. Refer to FRONT BUMPER .

-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .

-- Connect the coolant hose to the connector coupling. Refer to CONNECT THE COOLANT HOSE TO THE CONNECTOR COUPLING .

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

NOTE:

Used coolant cannot be used again.

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .

scientia non olet · About LEMON Manuals