Headlamp Mount, Removing And Installing: Installing
WARNING: This page is about a different car, the 2017 Audi A3, 2016 Audi A3, and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal. Note The Following:
-- Insert the headlamp mount and hand-tighten the bolt.
-- Install the headlamp. Refer to HEADLAMP, REMOVING AND INSTALLING .
-- Align the headlamp -1- according to the body contour gap dimensions.
- Gap dimension = even gap dimension.
-- If necessary, twist the nut -2- to adjust the height.
-- Tighten the screws -3 and 4- while aligning the headlamp so that it sits flush with the out edge of the fender.
-- Check gap dimensions again, repeat adjustment of gap dimensions if necessary, as described above.
-- Adjust the headlamp. Refer to HEADLAMP, ADJUSTING .