LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (ENGINE ASSEMBLY [4-Cylinder Direct Injection 1.8L; 2.0L 4V TFSI Engine] -- (A3)) >> 10 Engine Assembly >> SUBFRAME Mount >> Overview - SUBFRAME Mount >> Overview - SUBFRAME Mount, Vehicles With Manual Transmission 02S >> Engine Support - Tightening Specification And Sequence

Engine Support - Tightening Specification And Sequence

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
GWWA10-11481Courtesy of AUDI OF AMERICA, LLC
NOTE:

Replace the bolts that were tightened with an additional turn.

-- Tighten the bolts in the steps shown in the sequence:

Step Bolts Tightening Specification/Additional Turn
1. -1 to 3- 7 Nm
2. -1 to 3- 40 Nm
3. -1 to 3- 90° additional turn
scientia non olet · About LEMON Manuals