LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (CYLINDER HEAD, VALVETRAIN (4-Cylinder 2.0L 4V TFSI) -- (A3)) >> 15 Cylinder Head, VALVETRAIN >> Cylinder Head >> Overview - Cylinder Head >> Notes

Overview - Cylinder Head: Notes

WARNING: This page is about a different car, the 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of Cylinder Head Components
GWWA15-11287Courtesy of AUDI OF AMERICA, LLC
  1. Alignment Pin
    • Quantity: 2
  2. Cylinder Head Gasket
    • Always replace after removing
    • Installed position: the part number faces the cylinder head
    • Change the coolant and engine oil after replacing
  3. Cylinder Head
  4. Bolt
    • Tightening specification and sequence. Refer to Figure.
    • Always replace after removing
    • Loosening. Refer to Figure.
  5. Heat Shield
    • Equipped on some models
  6. Bolt
    • 9 Nm
  7. Bolt
    • 9 Nm
  8. Heat Shield
    • There are different versions. Refer to the parts information for the allocation.
  9. Bolt
    • 9 Nm
  10. Bolt
    • 9 Nm
  11. Connection
    • For coolant hose
  12. O-ring
    • Always replace after removing
    • Coat with coolant
  13. Bolt
    • Tightening Specifications and Sequence. Refer to Figure.
    • Always replace after removing
    • Loosening. Refer to Figure.
  14. O-ring
    • Always replace after removing
    • Coat with coolant
  15. Connection
    • For coolant hose
  16. Bolt
    • 9 Nm
  17. Mount
    • For the engine cover
  18. Engine Lifting Eye
  19. Bolt
    • 10 Nm + 90°
    • Always replace after removing
  20. Partition Plate
  21. Ball Pin
    • For the engine cover
  22. Engine Lifting Eye
  23. Bolt
    • 10 Nm + 90°
    • Always replace after removing
  24. Alignment Pin
scientia non olet · About LEMON Manuals