LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> RS 7 Performance >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System (Cylinder Head & VALVETRAIN - Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC) >> Cylinder Head, VALVETRAIN >> Timing Chain Cover >> Timing Chain Cover, Removing And Installing >> Right Timing Chain Cover, Removing And Installing >> Removing

Right Timing Chain Cover, Removing And Installing: Removing

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the vacuum pump. Refer to HYDRAULIC SYSTEM .

-- Remove the bolts -1 and 2-.

GWWA19-11417
CAUTION:

Danger of causing damage to the coolant pipe.

  • Do not bend the coolant pipe.

-- Remove the rear upper coolant pipe from the right cover for the timing chain guard in direction of -arrow- and set it aside.

NOTE:

The catalytic converter and the turbocharger support are removed to improve the clarity of the illustration.

Ignore item -2-.

-- Open the clamp -1- and remove the coolant hose.

GWWA10-11541

-- Disconnect the connectors -1 and 2-.

-- Remove the bolts -arrows- and move the mount -3- and wiring harness to the side.

GWWA15-11259

-- Remove the bolts in the following sequence: -8 to 1- counter-clockwise as shown.

GWWA15-11217

-- Carefully remove the right cover for the timing chain from the bond.

scientia non olet · About LEMON Manuals