Overview - Fuel Tank [CGXB, CAEB, CEUC, CHJA, CRDB, CAED, CTUA, CTGE, CREC, CWUB, CYNB]: Notes
Fig 1: Exploded View Of FUEL TANK [CGXB, CAEB, CEUC, CHJA, CRDB, CAED, CTUA, CTGE, CREC, CWUB, CYNB]
- Bolt
- 20 Nm
- Suspended Mount
- For exhaust system
- Individual components of the mount. Refer to Fuel Tank Suspended Mount, Mounting Strap and Ground Connection.
- Mounting Strap
- Individual components of the mount. Refer to Fuel Tank Suspended Mount, Mounting Strap and Ground Connection.
- Adjusting Buffer
- Individual components of the mount. Refer to Fuel Tank Suspended Mount, Mounting Strap and Ground Connection.
- Spacer Sleeve
- Individual components of the mount. Refer to Fuel Tank Suspended Mount, Mounting Strap and Ground Connection.
- Fuel Line
- From the fuel pressure regulator to the engine
- Do not kink
- Clipped to the fuel tank
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, SEPARATING .
- Shield
- For fuel filler tube
- Bolt
- 20 Nm
- Bolt
- 3.5 Nm
- Overflow Hose
- Fuel Filler Door Insert
- Cap
- Turn until it clicks and locks.
- Attached to the fuel filler door insert with an permanent fastener
- Bolt
- 20 Nm
- To attach the fuel filler neck
- Ground Connection
- For fuel filler tube
- For discharging electrostatic charge. Refer to Fuel Tank Suspended Mount, Mounting Strap and Ground Connection .
- Fuel Tank
- Removing and installing. Refer to FUEL TANK, REMOVING AND INSTALLING .
- Pay attention to the SVM code according to the Parts information
- Breather Line
- To the EVAP canister
- Do not kink
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, SEPARATING .
- Heat Shield
- For the fuel tank
- Lock Washer
- 2 Nm
- For heat shield
- Carrier Plate
- Bolt
- 20 Nm
- Heat Shield
- For the fuel tank
- Lock Washer
- 2 Nm
- For heat shield
- Expanding Clip
-- Route the ground connection as illustrated.
-- Make sure the following connectors are secure:
- Connector -2- for the ground connection on the threaded ring -1- of the fuel filler tube.
- Ground connector -6- on the fuel filler tube cover.
-- Attach the ground connection contact -4- to the hole in the fuel tank -3- and then install the spacer -5-.
WARNING:
Risk of explosion due to electrostatic charge.
- After installing, check electrical connection on fuel filler neck metal ring to an empty spot on the body using an Ohm meter.
- Specified value: approximately 0 Ω.