LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> RS 7 Performance >> Labor Times >> Other Variant >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the RS 7 Base, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
AllIncludes: Additional time for use of scan tool to perform this procedure.2.2B
Front1.0B
RearIncludes: Additional time for use of scan tool to perform this procedure.1.4B
Combination Procedure: BRAKE HOSE: Replace:
Includes: Bleed Brake System.
Each Additional0.2B
One0.4B
Combination Procedure: CALIPER: Overhaul:
Includes: Bleed Brake System.
Each Additional0.3B
One0.5B
Combination Procedure: CALIPER: Replace:
Includes: Bleed Brake System.
One0.4B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
0.5B
Combination Procedure: DISC ROTOR: Remove and Install for Refinishing:
This operation does not apply to drive axles. If on vehicle refinishing is not possible use appropriate repair operation. Includes: Pack Bearings (where applicable).
Each0.1B
Combination Procedure: DISC ROTOR: Replace:
Each0.1B
Combination Procedure: HEADLAMP ASSEMBLY: Adjustment:
Includes: Additional time for use of scan tool to perform this procedure.0.5C
Combination Procedure: LEVEL CONTROL SYSTEM: Calibrate:
With Use of Scan Tool.0.3B
Combination Procedure: PERIPHERAL CAMERA: Calibrate:
Includes: Additional time for use of scan tool to perform this procedure.1.0B
Combination Procedure: WHEEL BEARING: Replace:
Includes: Pack Bearings (where applicable).
Front,One Side1.3B
Rear,One SideDOES NOT include wheel alignment.1.0B