Left Seal, Replacing, 0BC: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Install Right Shaft Seal

Fig 1: Driving In New Seal To Stop, Without Canting Seal

Courtesy of AUDI OF AMERICA, LLC

-- Coat outer edge of the seal with axle oil.

-- Fill the space between the sealing lip and the dust lip halfway with Sealing Grease G 052 128 A1.

-- Drive in new shaft seal as far as stop without tilting it.

Installing Left Shaft Seal

Fig 2: Driving In New Seal To Stop, Without Canting Seal

Courtesy of AUDI OF AMERICA, LLC

-- Coat outer edge of the seal with axle oil.

-- Fill the space between the sealing lip and the dust lip halfway with Sealing Grease G 052 128 A1.

-- Drive in new shaft seal as far as stop without tilting it.

Right and Left Flange Shafts, Installing

Fig 3: Identifying Right/Left Flange Shafts

Courtesy of AUDI OF AMERICA, LLC

-- Install the flange shaft using the Needle Bearing Drift VW 295.

-- Install the rear final drive. Refer to FINAL DRIVE .

-- Check the gear oil in rear final drive. Refer to GEAR OIL, CHECKING LEVEL, 0BC .