Part II
WARNING: This page is about a different car, the 2019 Audi A5 Quattro and 2018 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Part I. Refer to Part I .
- Support
- Turbocharger
- Removing and installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING .
- O-Ring
- Always replace after removing.
- Coat with engine oil
- Line
- For the crankcase ventilation
- Do not separate versions with threaded connections -item ) Part II - List Item: Bolt/Threaded Connection from the turbocharger
- Bolt/Threaded Connection
- 9 Nm
- Depending on the version a bolt or a threaded connection with a connected hose is installed.
- Do not separate the threaded connection from the turbocharger
- Oxygen Sensor 1 Before Catalytic Converter -GX10-
- Removing and Installing. Refer to HEATED OXYGEN SENSOR, REMOVING AND INSTALLING .
- O-Ring
- Always replace after removing.
- Coat with engine oil
- Oil Supply Line
- Bolt
- 9 Nm
- O-Ring
- Always replace after removing.
- Coat with engine oil
- Bolt
- 9 Nm
- Bolt
- 30 Nm
- Coat the with hot bolt paste. Refer to the Parts Information.
- Heat Shield
- Bolt
- 9 Nm
- Coolant Supply Line
- O-Ring
- Always replace after removing.
- Coat with engine oil
- Bolt
- 9 Nm
- O-Ring
- Always replace after removing.
- Coat with coolant
- Bolt
- 20 Nm + 90°
- Always replace after removing.