Vehicles With Multi-Link Suspension - Rear Axle Toe: Procedure
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2017 Audi A3, and 2016 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the nut -A- on the lower control arm threaded connection from the subframe and loosely install a new nut.
-- Adjust toe by turning eccentric screw -B-.
NOTE:
The maximum adjustment range is 90° to left or right of center position.
-- Tighten the nut -A-.
-- After the nut -A- is tightened, check the toe value once more. Refer to AXLE ALIGNMENT SPECIFIED VALUES .