Maximum Steering Angle, Checking

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2017 Audi A3, and 2016 Audi S3. However, it is still accessible from the selected car via links, so may be relevant.

The wheel alignment computer determines the maximum steering angle.

-- If the maximum steering angle has been determined on the alignment equipment, so that the value is not within the tolerance, then check for damage or deformations to the steering and suspension components and inspect the symmetry of the ties rod. In this case, shorten the "longer" tie rod end (install it deeper onto the tie rod) and replace any damaged components.

-- If a steering wheel fault is determined on the alignment equipment when setting the center position of the steering, then check the steering and suspension for damage or deformations and replace any damaged components. Check the tie rod symmetry as well.

-- Measure the dimension -a- on the "shorter" tie rod head. Shorten the "longer" tie rod head to the same dimension. To do this, install the tie rod head -1- deeper on the tie rod -2-.

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- right tie rod end = dimension -a- left tie rod end; maximum permissible difference between right and left < 2 mm.

-- When the steering wheel returns to its center position, let the steering wheel "come to its center" using even movements.