3. Closing Locks, Checking, Vehicles With Keyless Stop And Start System
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Press the Access/Start Authorization Button -E408- briefly to get "ignition on".
-- Do not move the selector lever into "P" but rather, for example, into "N".
-- Turn off the ignition.
- A warning message must appear in the instrument cluster.
- The vehicle cannot be locked.
-- Switch on the ignition and shift the selector lever into the "P" position.
-- Turn off the ignition.
- The vehicle can be locked.
If the specified values are not obtained:
-- Use the Vehicle Diagnostic Tester in Guided Fault Finding for fault finding.
-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .
-- Check the locking button on the selector lever handle. Refer to 4. Selector Lever Handle Locking Button, Checking below.