LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> RS 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (CONTROLS, HOUSING [0D9] (1 Of 2) -- (A3 SEDAN)) >> 34 Controls, Housing >> Selector Mechanism >> Overview - Selector Mechanism

Overview - Selector Mechanism

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S3, 2017 Audi A3 Quattro, 2016 Audi S3, 2016 Audi A3 Quattro, and 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Selector Mechanism Exploded View
GWWA34-11156Courtesy of AUDI OF AMERICA, LLC
  1. Selector Lever Cable
    • Cannot be replaced separately
    • Do not lubricate
  2. Nut
    • 8 Nm
    • For selector mechanism to body
    • Quantity: 4
  3. Bolt
    • 4 Nm
    • For the selector mechanism to the selector housing
    • Quantity: 4
  4. Selector Mechanism
    • The following components are combined into a single component
      • Selector Lever -E313-
      • Selector Lever Sensor System Control Module -J587-
      • Selector Lever Park Position Lock Switch -F319-
      • Shift Lock Solenoid -N110-
      • Selector lever cable
    • The components cannot be replaced separately
    • To check the components, use the Vehicle Diagnostic Tester in Guided Fault Finding 
    • Selector mechanism emergency release. Refer to EMERGENCY RELEASE FROM P .
    • Selector mechanism, removing and installing. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING .
  5. Selector Housing
  6. Base Plate
    • Always replace after removing
  7. Clips
    • Always replace after removing
  8. Bolt
    • 13 Nm
    • Selector lever cable adjusting bolt
  9. Joint Piece
  10. Selector Lever
  11. Nut
    • 20 Nm
  12. Lock Washer
  13. Cable Bracket
    • For the selector lever cable
  14. Bolt
    • 15 Nm
scientia non olet · About LEMON Manuals