Wheel Bearing Housing Bonded Rubber Bushing, Replacing: Removing: Notes

-- Before beginning work measure the distance from the center of wheel to lower edge of wheelhouse. Refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .

-- Remove the wheel. Refer to WHEEL, CHANGING AND MOUNTING

-- Remove coil spring. Refer to SPRING, REMOVING AND INSTALLING .

Vehicle with a Vehicle Inclination Sensor -G384- : 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- at the left and right on the linkage -2- for the rear Vehicle Inclination Sensor -G384-.

Vehicles with Stone Chip Protection 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the expanding rivets -1-.

-- Remove the bolts -2- and the stone chip protection -3-.

Continuation for All Vehicles 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -1- from the coupling rod -2-.

-- Remove the coupling rod -2- from the stabilizer bar -3-.

-- Remove the nut -1- and then the bolt -2- for the shock absorber threaded connection.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -3- and then the bolt -4- for the wheel bearing housing threaded connection.