Spring, Removing And Installing, Torsion Beam Axle: Installing

Installation Is Reverse Of Removal, Noting The Following: 

-- Make sure the spring support is not damaged.

-- If necessary, replace the spring support.

-- Install the spring support on the lower coil spring.

• The spring start -arrow- must touch bottom of spring seat.

  Courtesy of AUDI OF AMERICA, LLC

-- Install the spring and the spring support.

-- The spring support has a pin on bottom.

-- Insert this pin into the lower spring mount hole on the axle beam.

-- Install the top of the spring support into the upper spring end.

-- The bead on the spring support -arrow- must fit into the coil spring correctly.

Courtesy of AUDI OF AMERICA, LLC

-- Release the tension on the spring, guiding upper spring support onto tab of body.

-- Remove the :VAG1752/1  .

-- Press in the clip -1- in the reverse direction of the -arrow- until stop.

Courtesy of AUDI OF AMERICA, LLC