Stabilizer Bar, Removing And Installing, Multi-Link Suspension Vehicles With Front Wheel Drive: Notes
WARNING: This page is about a different car, the 2017 Audi A3, 2016 Audi A3, and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Torque Wrench 1331 5-50 Nm :VAG1331
- Torque Wrench 1331 Insert - Ring Wrench - 16mm :VAG1331/12
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolt - Coupling Rod to Stabilizer Bar
- Bolt - Stabilizer Bar to Subframe
NOTE:
When loosening or tightening the nut to secure the coupling rod to the stabilizer bar, counterhold on the respective coupling rod stud to prevent it from rotating.
The counter hold tool cannot be tilted.
The following work steps are described for the left side of the vehicle. These work steps also apply simultaneously for right side of vehicle.