Coupling Rod, Removing And Installing: Notes
WARNING: This page is about a different car, the 2017 Audi A3, 2016 Audi A3, and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Torque Wrench 1331 5-50 Nm :VAG1331
- Torque Wrench 1331 Insert - Ring Wrench - 16mm :VAG1331/12
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolt - Coupling Rod to Stabilizer Bar
- Bolt/Nut - Coupling Rod to Lower Transverse Link
NOTE:
When loosening or tightening the nuts to secure the coupling rod to the stabilizer bar, counterhold on the respective coupling rod stud to prevent it from rotating.
The counter hold tool cannot be tilted.