Coupling Rod, Removing And Installing: Installing
WARNING: This page is about a different car, the 2017 Audi A3, 2016 Audi A3, and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Installation Is Reverse Of Removal, Noting The Following:
-- Insert the coupling rod -2-, install the nuts -1 and 3- and tighten in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .
- When tightening the nut -1-, counterhold at the inner multi-point fitting of the bolt.