Front Three-Point Seat Belt, Removing And Installing: Installing

WARNING: This page is about a different car, the 2017 Audi A3, 2016 Audi A3, and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all pyrotechnic components safety precautions, refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

Install In Reverse Order Of Removal. Note The Following:

-- If parts of the seat belt system are removed due to an accident, replace the belt system bolts.

NOTE:

Make sure the connectors are installed correctly and are secure.

After replacing the control module -J854- / -J855- the control module must be coded, refer to Vehicle Diagnostic Tester.

-- Insert the automatic belt retractor with the anti-twist mechanism -1- in the mount in direction of -arrow- and tighten the bolt.

Courtesy of AUDI OF AMERICA, LLC

-- Attach the connector -1- to the igniter in direction of -arrow A-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the connector locking mechanism -2- -arrow B-. While doing this, the connector is pushed into the igniter and locks into place.

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

-- Connect the battery GND cable with the ignition turned on, refer to BATTERY, DISCONNECTING AND CONNECTING (A3 / A3 CABRIOLET) .