Rollover Protection, Removing And Installing: Installing
Follow the safety precautions for the rollover protection, refer to SAFETY PRECAUTIONS FOR ROLLOVER PROTECTION .
Install In Reverse Order Of Removal. Note The Following:
Make sure the connectors are installed correctly and are secure.
Make sure the wires do not get caught.
-- Install the rear three-point seat belt, refer to INSTALLING .
Make sure no one is standing near the rollover protection when reconnecting the battery. Stand at least 1 meter away.
-- Connect the battery GND cable with the ignition turned on, refer to BATTERY, DISCONNECTING AND CONNECTING (A3 / A3 CABRIOLET) .
-- ALWAYS perform an output diagnostic test under "Guided Functions" after repairing the rollover protection and only after all work procedures are completed (also if new rollover protection was installed), refer to Vehicle Diagnostic Tester.
Installation note: For example tightening specifications, replace components, refer to ROLLOVER PROTECTION ASSEMBLY OVERVIEW , OVERVIEW - REAR OUTER THREE-POINT SEAT BELT .