LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> RS 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Passenger Protection, Airbags, Seat Belts -- (Cabriolet)) >> 69 Passenger Protection, Airbags, Seat Belts >> Passenger Occupant Detection System >> Passenger Occupant Detection System, Removing And Installing >> Notes

Passenger Occupant Detection System, Removing And Installing: Notes

WARNING: This page is about a different car, the 2017 Audi A3, 2016 Audi A3, and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The passenger occupant detection system is only installed in the passenger seat.

WARNING:

The replacement part (Service Kit) for the passenger occupant detection system (country-specific) is already pre-installed. Never disconnect the connector between the Passenger Occupant Detection System Control Module -J706- and the Front Passenger Seat Occupant Sensor -G128-. The Service Kit differs depending on the seat version and consists of:

  • Seat cushion with/without a seat heating element
  • Front Passenger Seat Occupant Sensor -G128- attached to the seat cushion
  • Passenger Occupant Detection System Control Module -J706-
scientia non olet · About LEMON Manuals