Front Passenger Seat Occupied Sensor -G128-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2017 Audi A3, 2016 Audi A3, and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Follow all pyrotechnic components safety precautions, refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Disconnect the battery GND cable with the ignition turned on, refer to BATTERY, DISCONNECTING AND CONNECTING (A3 / A3 CABRIOLET) .
-- Remove the front passenger seat, refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Fasten the front seat on the Engine/Transmission Holder - Seat Repair Fixture:VAS6136 , refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove seat backrest seat cover and cushion, refer to SEAT PAN COVER AND CUSHION, REMOVING AND INSTALLING .
-- Disconnect the electrical harness connector for the seat occupied sensor.
-- Unclip the clips -1- from the seat backrest and remove the seat occupied sensor -2-.