Drive Plate, Removing And Installing, Automatic Transmission: Installing
Install in reverse order of removal and note the following:
- Replace the bolts that were tightened with an additional turn after removing them.
-- First position the drive plate without the washer -A-.
-- Insert the used bolts -3- and tighten them to 30 Nm.
-- Check the dimension between the drive plate and the cylinder block in three locations and calculate the average.
TIP:
This is measured through the hole in the drive plate to the machined surface of the cylinder block. When measuring on the intermediate plate, take the thickness of the plate into consideration.
- Specified value measured without intermediate plate: 19.5 to 21.1 mm
- Specified value measured with intermediate plate: 18.8 to 20.4 mm
If the specified value is reached, replace all bolts and tighten them.
If the specified value is not obtained:
-- Remove the drive plate again and use the shim -A-. Tighten the bolts -3- to 30 Nm again.
-- Repeat the measurement. If the specified value is reached, replace all bolts and tighten them.