Overview - Cylinder Block, Belt Pulley Side, Version 2

Fig 1: Cylinder Block, Belt Pulley Side Exploded View

Courtesy of AUDI OF AMERICA, LLC

1. Ribbed Belt
   • Check for wear
   • Before removing, mark the running direction using chalk or a felt-tip pen. Reversing the running direction on a used belt can destroy it
   • Do not kink
   • When installing, make sure it is seated correctly on the belt pulleys
   • Removing and installing. Refer to RIBBED BELT, REMOVING AND INSTALLING 
   • Ribbed belt routing. Refer to Figure.
2. Ribbed Belt Tensioner
   • To release the tension on the ribbed belt, pivot using an open end wrench.
   • Secure using the Locking Pin:T10060A 
   • Removing and installing. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING
3. Bolt
   • 40 Nm
4. Bolt
   • 150 Nm + 90°
   • Always replace after removing.
   • Coat the O-ring with engine oil
5. O-ring
   • Not a replacement part; supplied with the bolt
6. Vibration Damper
   • With the ribbed belt pulley
   • Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
7. Bolt
   • Tightening Specifications and Sequence. Refer to  14.
8. Sub-Assembly Bracket
   • With oil filter and engine oil cooler
   • Removing and installing the sub-assembly bracket. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
   • Removing and installing the engine oil cooler. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
9. Seal
   • Always replace after removing.
10. Bolt
    • Tightening specification. Refer to OVERVIEW - GENERATOR .
11. Generator
    • Removing and installing. Refer to GENERATOR, REMOVING AND INSTALLING .
12. A/C Compressor
    • Do not remove or disconnect the refrigerant lines
    • Removing and installing. Refer to A/C Compressor, Removing And Installing .
13. Alignment Sleeve
    • For the A/C compressor
14. Bolt
    • Tightening specification. Refer to Overview - A/C Compressor Power Unit .

Courtesy of AUDI OF AMERICA, LLC

• Replace the bolts that were tightened with an additional turn after removing them.

-- Mount the sub-assembly bracket and then install the bolts -4- first.

-- Tighten the bolts in the steps shown in the sequence: