Overview - Balance Shaft
- Bolt
- 9 Nm
- Always replace after removing.
- Balance Shaft
- Always replace after removing.
- Intake side
- Lubricate the bearing with engine oil
- Replacing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, INTAKE SIDE .
- Balance Shaft
- Replace after removing.
- Lubricate the bearing with engine oil
- Replacing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, INTAKE SIDE .
- Bolt
- 9 Nm
- Always replace after removing.
- Balance Shaft Pipe
- Installation position. Refer to the illustration below.
- Seal
- For balance shaft intake side (coolant pump drive)
- Replacing. Refer to BALANCE SHAFT SEAL, REPLACING, INTAKE SIDE .
- The pin from the balance shaft pipe must fit into the groove -arrow-.