Balance Shaft Seal, Replacing, Intake Side: Procedure

-- Remove the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

TIP: 

The drive wheel bolt has a left thread.

-- Remove the bolt -2- and then remove the drive wheel -1- for the coolant pump toothed belt.

Courtesy of AUDI OF AMERICA, LLC

-- Firmly press a screwdriver -1- on the surface of the sealing ring -2- in direction of -arrow B-.

Courtesy of AUDI OF AMERICA, LLC

-- Pry out the sealing ring in direction of -arrow A-.

-- Clean the contact and sealing surface.

-- Coat the sealing surface of the balance shaft -2- with transmission fluid.

Courtesy of AUDI OF AMERICA, LLC

-- Push the sealing ring -1- onto the balance shaft.

• "Luftseite" or ("Outside") -arrow- must be readable from the outside.

TIP: 

Courtesy of AUDI OF AMERICA, LLC

The drive wheel bolt has a left thread.

-- Depending on the version mount the Seal Installer - Intermediate Shaft:T10353  or :T10353/1  on the seal -1- and then tighten it all the way into the cylinder block with the bolt -2-. Be careful not to tilt the seal when doing this.

-- Install the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .