All Wheel Drive Clutch Pump -V181-, REMOVING AND INSTALLING, GENERATION IV: Installing

Install in reverse order of removal. Note the following:

-- Replace the O-rings -1 and 2-.

-- Lightly coat the O-rings -1 and 2- with High Performance All Wheel Drive Clutch Oil.

-- Press the pump -arrow- in up to the stop. Make sure the cable protector -2- is routed correctly.

-- Tighten the bolts -1-. Tightening specification, refer to -item  13- OVERVIEW - ALL WHEEL DRIVE CLUTCH, GENERATION IV.

-- Remove the fastening bolt -arrow- at the front mounting bracket.

-- Clip the wiring harness to the all wheel drive clutch securely and place the connector -arrow- on the control module.

-- Secure rear final drive to subframe with a new bolt -arrow-. Tightening specification, refer to -item  1- OVERVIEW - FINAL DRIVE.

-- Add High Performance All Wheel Drive Clutch Oil and check the oil level in the all wheel drive clutch. Refer to ALL WHEEL DRIVE CLUTCH OIL LEVEL, CHECKING .