LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> A6 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Seat Belt Warning System (Diagnostics & Symptom Tests)) >> Seat Belt Warning System >> Data List / Active Test [08/2013 - ] >> Data List / Active Test [08/2013 - ]

Data List / Active Test [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Combination Meter, Occupant Detection*1 or SRS Airbag / Data List.
    5. Read the Data List according to the display on the Techstream.
      COMBINATION METER

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      P-Seatbelt Buckle SW*2 Front passenger seat belt buckle switch signal/ON or OFF ON: Front passenger seat belt unfastened
      OFF: Front passenger seat belt fastened      		 The front passenger seat is occupied
      Driver Side Seatbelt Warning Buzzer Driver seat belt warning buzzer/ON or OFF Customized value displayed -
      P-Seatbelt Warning Buzzer Front passenger seat belt warning buzzer/ON or OFF Customized value displayed -
      OCCUPANT DETECTION*1

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Passenger Buckle SW Front passenger buckle switch/Set, Unset or NG Set: Seat belt fastened
      Unset: Seat belt not fastened
      NG: Data is not determined      		 -
      SRS AIRBAG

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Left side Buckle SW LH buckle switch/Unset, Set or NG Unset: Seat belt not fastened
      Set: Seat belt fastened
      NG: Data is not determined      		 -
      Right side Buckle SW*1 RH buckle switch/Unset, Set or NG Unset: Seat belt not fastened
      Set: Seat belt fastened
      NG: Data is not determined      		 -
      • *1: w/ Occupant Classification System
      • *2: w/o Occupant Classification System
  2. ACTIVE TEST 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
    5. Perform the Active Test according to the display on the Techstream.
      COMBINATION METER

      Tester Display Test Part Control Range Diagnostic Note
      Driver Side Seat Belt Seat belt warning light OFF/ON -
scientia non olet · About LEMON Manuals