Pinpoint Test C : B142E:78 Or B1433:54
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
- C1 INSPECT THE CCM (CRUISE CONTROL MODULE) BRACKET
- Remove the front bumper trim panel. REFER to: Cruise Control Module (CCM) .
- Inspect for damage to the CCM bracket and cruise control radar attachments to the bracket.
Is the CCM bracket or radar attachments to the bracket damaged?
Yes INSTALL a new CCM bracket or radar attachments, as necessary. REFER to: Cruise Control Module (CCM) . No GO to C2 - C2 PERFORM THE CRUISE CONTROL RADAR ALIGNMENT
- Perform the cruise control radar alignment procedure. REFER to: Cruise Control Radar Alignment .
Is the CCM aligned correctly?
Yes The system is operating correctly at this time. The concern was caused by a misaligned CCM. No GO to C3 - C3 CHECK FOR CORRECT CCM (CRUISE CONTROL MODULE) OPERATION
- Ignition OFF.
- Disconnect and inspect CCM connectors.
- Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
- Reconnect the CCM connectors. Make sure they seat and latch correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new CCM. REFER to: Cruise Control Module (CCM) . No The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.