Pinpoint Test F : B129C:98, B129D:98, B13F3:98, B13F4:98
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
- F1 CHECK THE DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE PAM (PARKING ASSIST CONTROL MODULE) SELF-TEST
- Ignition ON.
- Using a diagnostic scan tool, perform the PAM self-test.
- Check the PAM Diagnostic Trouble Codes (DTCs) from the self-test.
Are parking aid Diagnostic Trouble Codes (DTCs) other than B129C:98, B129D:98, B13F3:98, or B13F4:98 recorded?
Yes For all other Diagnostic Trouble Codes (DTCs) REFER to PAM DTC Chart . No GO to F2 - F2 CHECK THE PARKING AID SENSOR FOR PROPER VENTILATION
- Clean the front bumper and sensors with high-pressure water.
- Make sure the suspect parking aid sensor(s) is flush-mounted in the bezel.
- Check for damage, debris or any aftermarket air dams that may restrict sensor ventilation.
- Check for aftermarket exhaust or other aftermarket parts.
Is there any damage or aftermarket parts restricting the ventilation to the sensor(s)?
Yes REPAIR or REMOVE the aftermarket parts as needed. No GO to F3 - F3 CHECK THE PARKING AID SENSORS
- Ignition OFF.
- Install a known good sensor for the suspect parking aid sensor. For a front sensor REFER to: Front Active Park Assist Sensors . For a rear sensor REFER to: Rear Active Park Assist Sensors .
- Ignition ON.
- Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs) and repeat the PAM self-test.
Is the concern still present?
Yes GO to F4 No The cause of the concern was an inoperative parking aid sensor. The system is now operating correctly. - F4 CHECK FOR CORRECT PAM (PARKING ASSIST CONTROL MODULE) OPERATION
- Ignition OFF.
- Disconnect and inspect all PAM connectors.
- Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
- Reconnect the PAM connectors. Make sure they seat and latch correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new PAM. REFER to: Parking Assist Control Module (PAM) . No The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.