Cylinder Bank 1 (Right):
WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The engine could be damaged.
- The camshaft adjuster must only be installed according to the following work steps.
-- Install the camshaft adjuster according to the marks applied during removal.
- The groove -1 and/or 4- in the camshaft adjuster must align with the adjustment window -2 and/or 3-.
-- Install the camshaft adjuster according to the marks applied during removal.
-- Position the camshaft timing chain on the drive sprocket and the camshaft adjuster and loosely install bolts -1 and 2-.
- Both camshaft adjusters must be able to still be rotated on camshaft and must not tip.
-- Remove the :T40071 .
-- Position the :T40269 on the camshaft adjuster for the intake camshaft.
-- Position the :VAG1332 with the :VAG1332/9 on the :T40269 .
-- Have a second technician pre-tension the camshaft adjuster in the direction of -arrow- to 40 Nm.
-- Tighten the bolts as follows while the camshaft adjuster is still held under tension.
| Step | Bolt | Tightening Specification |
|---|---|---|
| 1. | -1- | To the camshaft to 60 Nm |
| 1. | -2- | To the camshaft to 60 Nm |
-- Remove the :T40269 .
-- Remove the :T40264/1 -arrows-.