Right cylinder head:

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front coolant pipe. Refer to FRONT COOLANT PIPE, REMOVING AND INSTALLING .

-- Remove the upper coolant pipe. Refer to UPPER COOLANT PIPE, REMOVING AND INSTALLING .

-- Remove the union nut -right arrow- and then remove the high pressure line -1-.

NOTE:

Ignore -left arrow-.

-- Loosen the clamp -arrow- and remove it.

Courtesy of AUDI OF AMERICA, LLC

-- Remove bolt -2-, Remove the intermediate pipe from the right air duct pipe.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -item 1-.

-- Remove nut -1-, remove the bracket -2- for the right air duct pipe.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right air duct pipe toward the rear.

-- Remove the banjo bolt -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the guide pins for the glide track -1- and for the tensioning rail -2-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore :T40246 .

Continued for both sides:

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the cylinder head bolts in the sequence -1 to 8-.

-- Remove the bolts and the cylinder head carefully.

CAUTION:

Danger of damaging the glow plugs when removing the cylinder head.

do not lay the removed cylinder head on the sealing surface with the glow plugs installed otherwise the glow plugs will protrude slightly past the sealing surface