Removal And Installation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- 1.
With the seat in the E-Z entry position, release the rear J-clip and partially invert the cushion cover.
 Courtesy of FORD MOTOR COMPANY
|
- 2.
Release the trim cover J-clips from both sides of the cushion.
- 3.
Release the outer and inner rear J-clips from the cushion.
- 4.
If equipped, disconnect and detach the cushion heater mat electrical connector and heater mat wiring.
 Courtesy of FORD MOTOR COMPANY
|
- 5.
Latch the seat to the floor and raise the backrest.
- 6.
Release the front J-clip from the cushion.
- 7.
Release the 2 cushion trim cover retainers from the 2 child safety seat lower anchors and tethers for children anchors.
- Pull the cushion trim cover rearward and release the 2 clips.
 Courtesy of FORD MOTOR COMPANY
|
- 8.
NOTE:
Use care when separating the seat cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the seat cushion foam.
Separate the hook-and-loop strips and invert the cushion trim cover to the row of hog rings.
- 9.
Remove the row of hog rings.
- 10.
Remove the cushion trim cover.
- Route the trim cover from between the cushion and backrest.
- 11.
To install, reverse the removal procedure.