Removal And Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

NOTE: Do not pull down on the front of the overhead console.

Pull down on the rear of the overhead console to remove the overhead console from the retaining clips.
- Disconnect the electrical connectors.

2.

Release the 4 retaining clips and remove the lamp assembly from the overhead console.

GFD137065

Courtesy of FORD MOTOR COMPANY

3.

Release the 6 retaining clips and remove the lens from the lamp assembly.
- NOTE: The bulbs can be pushed out from the backside of the lamp assembly.
  
  Replace the bulb(s) as necessary.

GFD137066

Courtesy of FORD MOTOR COMPANY

4.

To install, reverse the removal procedure.