Removal And Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Extend the Power Running Board(PRB).

2.

NOTE: An assistant is required to hold the Power Running Board(PRB) before removing the bracket-to-step screws. Failure to follow this direction may result in damage to the component.

Remove the 2 front and 2 rear bracket-to-step screws and the PRB step.
- To install, tighten to 12 Nm (106 lb-in).

Courtesy of FORD MOTOR COMPANY

3.

To install, reverse the removal procedure.