Removal And Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting .

2.

NOTE: If the Power Running Board(PRB) cannot be extracted, extend the running board by hand.

Extend the PRB.

3.

Disconnect the PRB motor electrical connector.

GFD137249

Courtesy of FORD MOTOR COMPANY

4.

NOTE: An assistant is required to hold the Power Running Board(PRB) before removing the lower bolts. Failure to follow this instruction may result in damage to the component.

NOTE: Only 3 bolts shown.

Remove the front PRB upper and lower bolts.
- To install, tighten to 23 Nm (17 lb-ft).

GFD137250

Courtesy of FORD MOTOR COMPANY

5.

Remove the rear PRB upper and lower bolts and remove the PRB assembly.
- To install, tighten to 23 Nm (17 lb-ft).

GFD137251

Courtesy of FORD MOTOR COMPANY

6.

To install, reverse the removal procedure.