Pinpoint Test B : A Virtual Gauge (Power Distribution, Tachometer Or Temperature) Is Inoperative

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

B1 VERIFY THE IPC IS SET TO DISPLAY THE GAUGE

Ignition ON.

NOTE: The IPC and message center navigation can be found in the Owner's Literature.

Using the message center controls, make sure the IPC is set to display the gauge in question.

Is the IPC set to display the gauge?

Yes	GO to B2.
No	The virtual gauge is operating correctly. The IPC was not set to display the gauge in question.

B2 PERFORM THE IPC SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
- Check for recorded DTCs from the IPC self-test.
Are any DTCs recorded?

Yes REFER to DTC Chart: IPC .

No GO to B3.

B3 PERFORM THE TCCM SELF-TEST
- Using a diagnostic scan tool, perform the TCCM self-test.
- Check for recorded DTCs from the TCCM self-test.
Are any DTCs recorded?

Yes REFER to Four Wheel Drive (4WD) Systems .

No GO to B4.

B4 PERFORM THE PCM KOEO SELF-TEST
- Using a diagnostic scan tool, perform the PCM KOEO self-test.
- Check for recorded DTCs from the PCM KOEO self-test.
Are any DTCs recorded?

Yes REFER to Electronic Engine Controls .

No Refer to IPC Hardware Testing .