Inspection Procedure

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work. Refer to PRECAUTION [08/2013 - ] .

HINT:

Perform the simulation method by selecting check mode (Signal Check) using the Techstream. Refer to CHECK MODE PROCEDURE [08/2013 - ] .
After selecting check mode (Signal Check), perform the simulation method by wiggling each connector of the airbag system or driving the vehicle on a city road or rough road. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2013 - ] .