DTC B2779: Engine Starter Communication Malfunction [08/2013 - ]: Procedure

1. Turn the power switch off.
2. Connect the Techstream to the DLC3.
3. Turn the power switch on (IG).
4. Turn the Techstream on.
5. Enter the following menus: Body Electrical / Smart Access / Data List.
6. Read the Data List according to the display on the Techstream.
   SMART ACCESS
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Wireless C Code	Registration status between remote engine starter ECU and certification ECU (smart key ECU assembly)/No Regd or Regd	No Regd: ID not registered between remote engine starter ECU and certification ECU (smart key ECU assembly) Regd: ID registered between remote engine starter ECU and certification ECU (smart key ECU assembly)	Problems may be caused by the following: Remote engine starter ECU registration has not been performed. Malfunctions in the certification ECU (smart key ECU assembly) or remote engine starter ECU.

   OK

   "Regd" is displayed on the Techstream screen.

   RESULT
   
   

   Result	Proceed to
   "No Regd" is displayed on the Techstream screen.	A
   "Regd" is displayed on the Techstream screen.	B

B → See step   4 

A: Go to next step 

1. Register the remote engine start ID.

NEXT: Go to next step 

1. Check that the hybrid control system can be started using remote engine start operation.

   OK

   Hybrid control system can be started using remote engine start operation.

NG → See step   4 

OK → END (REMOTE ENGINE START ID WAS NOT REGISTERED CORRECTLY) 

HINT: 

In this repair information, only the terminal numbers used for inspection between the main body ECU (multiplex network body ECU) and option connector are listed.

1. Disconnect the H10 main body ECU (multiplex network body ECU) connector.
2. Disconnect the H151 option connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H10-25 (BTX) - H151-7 (BTX)	Always	Below 1 Ω
   H10-26 (BRX) - H151-3 (BRX)	Always	Below 1 Ω
   H10-25 (BTX) - Body ground	Always	10 kΩ or higher
   H10-26 (BRX) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Temporarily replace the remote engine starter ECU with a new one.
2. Register the remote engine start ID.
3. Check that the hybrid control system can be started using remote engine start operation.

   OK

   Hybrid control system can be started using remote engine start operation.

NG → See step   6 

OK → END (REMOTE ENGINE STARTER ECU WAS DEFECTIVE) 

1. Temporarily replace the main body ECU (multiplex network body ECU) with a new or known good one. Refer to REMOVAL [08/2013 - ] .
2. Check that the hybrid control system can be started using remote engine start operation.

   OK

   Hybrid control system can be started using remote engine start operation.

NG → See step   7 

OK → END (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) WAS DEFECTIVE)