Open in One Side of CAN Branch Line [08/2013 - ]: Procedure

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR OPEN IN ONE SIDE OF V BUS BRANCH LINE
1. Based on the vehicle equipment and specifications, confirm the systems that use CAN communication. Refer to DIAGNOSIS SYSTEM [08/2013 - ] .
2. Using the Techstream, select and perform the CAN bus check. Refer to DIAGNOSIS SYSTEM [08/2013 - ] .
3. Observe the screen for approximately 2 minutes to check the ECUs and sensors that are not displayed on the screen and also those that repeatedly appear and disappear from the screen.
4. Check the applicable communication stop mode for the ECU or sensor that is not displayed on the screen.
NEXT → See step 2
GO TO CORRESPONDING COMMUNICATION STOP MODE. Refer to PROBLEM SYMPTOMS TABLE [08/2013 - ]