DTC B2624: Vehicles Speed Malfunction [08/2013 - ]: Procedure

1. Check for DTCs. Refer to DIAGNOSIS SYSTEM [08/2013 - ] .

   OK

   DTC is not output.

NG → See step   3 

OK: Go to next step 

1. Turn the power switch off.
2. Connect the Techstream to the DLC3.
3. Turn the power switch on (IG).
4. Turn the Techstream on.
5. Check the vehicle speed signal on the Techstream.
6. Enter the following menus: Body Electrical / Tilt & Telescopic / Data List.
   TILT & TELESCOPIC
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Freeze Speed Info	Vehicle speed data/ Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph)	Stop → Drive → Stop	0 km/h (0 mph) → Same speed as indicated on speedometer → 0 km/h (0 mph)

   Result

   Result	Proceed to
   Values indicated on the Techstream are normal.	A
   Values indicated on the Techstream are abnormal.	B

   HINT: 

   A vehicle speed of 3 km/h (2 mph) or more may be displayed on the Techstream immediately after the vehicle comes to a sudden stop. This is caused by a delay in vehicle signal received via CAN communication and is not a malfunction.

B → See step   4 

A → See step   5